Hi,
My name is Stephen. '69 Fiat Spider was my first car, and I still have it, though sitting in storage for 20+ years. Nice to read some of the stories on this site, brings back some memories. I have one picture of it online, probably around 1989 or 1990.
New member
- RRoller123
- Patron 2020
- Posts: 8179
- Joined: Sun Nov 13, 2011 2:04 pm
- Your car is a: 1980 FI SPIDER 2000
- Location: SAGAMORE BEACH, MA USA
Re: New member
Welcome aboard! That is very cool that you still have the car! You will find lots of friendly and helpful people here.
Pete
Pete
'80 FI Spider 2000
'74 and '79 X1/9 (past)
'75 BMW R75/6
2011 Chevy Malibu (daily driver)
2010 Chevy Silverado 2500HD Ext Cab 4WD/STD BED
2002 Edgewater 175CC 80HP 4-Stroke Yamaha
2003 Jaguar XK8
2003 Jaguar XKR
2021 Jayco 22RB
2019 Bianchi Torino Bicycle
'74 and '79 X1/9 (past)
'75 BMW R75/6
2011 Chevy Malibu (daily driver)
2010 Chevy Silverado 2500HD Ext Cab 4WD/STD BED
2002 Edgewater 175CC 80HP 4-Stroke Yamaha
2003 Jaguar XK8
2003 Jaguar XKR
2021 Jayco 22RB
2019 Bianchi Torino Bicycle
-
- Posts: 548
- Joined: Tue Oct 27, 2009 10:17 pm
- Your car is a: 1982 Spider
- Location: Cincinnati OH
Re: New member
Nice. I hope you have it under cover most of the time. Is that an older VW bug next to it?
Steve
1982 Red Spider 2000
1919 Old Town Sailing Canoe
1982 Red Spider 2000
1919 Old Town Sailing Canoe
Re: New member
Yes, it is in a garage, but about 400 miles away from me. Unfortunately someone broke in where it was stored a couple of years ago and though they didn't take or damage it, did take the keys which leaves me in a bit of a fix. I want to bring it home to restore, but will have to decide to sell my current "garage queen" first, a 1992 Mitsubishi 3000GT VR-4.
Yes that is a 66 Beetle convertible that my Dad still has, but in much much worse shape now.
The story of my Fiat:
My Dad bought it in the late 70's needing "some work." I don't recall it moving much. When I was 15 he let me start working on it. Body work was its primary requirement. It had bondo cracking and flaking off the hood and trunk. I did all the body work (learning as I went, making lots of mistakes) and also got it running, replaced the timing belt and other maintenance items. My dad and I finally painted it around 1986 or so in its original green (which I thought looked lighter than what was on it). I drove it through high school. One particular trip I remember was in about '88. I was going to a summer camp a few hundred miles away. It was sweltering hot and about 50 miles out of town the engine stopped. It would turn over but not start. After it cooled off a bit, and with some starting fluid, it started up. I pressed on instead of turning back, and about 100 miles later, on I40 in the middle of Memphis, it did it again. I was out of starting fluid, so I drained some gas from the tank into a little jar, and poured a little into the carb. It would run for a few seconds, then sputter and die. So I started it and dribbled gas in from the jar to keep it running. It backfired and caught the jar on fire and I threw it away. Horrifyingly stupid when I look back on it, but I was young. It seemed to mostly run after that. After a got to my destination, I figured out it was vapor-locking and the mechanical fuel pump just wasn't cutting it. I couldn't get another one at the time so I bypassed it and installed an electric pump in the trunk. It ran ok after that but super rich (so probably too much fuel pressure from the electric pump). I drove it for a while in college. My amateur body work started cracking and flaking. I didn't want to take it with me when I transferred to a college in Pittsburgh, PA. So essentially it has been sitting around since then.
Also around my late HS/early college years my Dad and I repaired a blue 1975 Fiat that was pretty rusty. It had come from Colorado. Rear wheel arches were totally gone, carpet was the only thing keeping water from splashing in through the holes in the floor, and the back bumper fell off while we were driving it. It was a real treat. Got it in pretty good shape with a nice coat of red paint and my sister drove it while she was in high school. They sold it while I was away with my original 69 wheels and hubcaps
Hope I didn't bore anybody too much.
--
Stephen
Yes that is a 66 Beetle convertible that my Dad still has, but in much much worse shape now.
The story of my Fiat:
My Dad bought it in the late 70's needing "some work." I don't recall it moving much. When I was 15 he let me start working on it. Body work was its primary requirement. It had bondo cracking and flaking off the hood and trunk. I did all the body work (learning as I went, making lots of mistakes) and also got it running, replaced the timing belt and other maintenance items. My dad and I finally painted it around 1986 or so in its original green (which I thought looked lighter than what was on it). I drove it through high school. One particular trip I remember was in about '88. I was going to a summer camp a few hundred miles away. It was sweltering hot and about 50 miles out of town the engine stopped. It would turn over but not start. After it cooled off a bit, and with some starting fluid, it started up. I pressed on instead of turning back, and about 100 miles later, on I40 in the middle of Memphis, it did it again. I was out of starting fluid, so I drained some gas from the tank into a little jar, and poured a little into the carb. It would run for a few seconds, then sputter and die. So I started it and dribbled gas in from the jar to keep it running. It backfired and caught the jar on fire and I threw it away. Horrifyingly stupid when I look back on it, but I was young. It seemed to mostly run after that. After a got to my destination, I figured out it was vapor-locking and the mechanical fuel pump just wasn't cutting it. I couldn't get another one at the time so I bypassed it and installed an electric pump in the trunk. It ran ok after that but super rich (so probably too much fuel pressure from the electric pump). I drove it for a while in college. My amateur body work started cracking and flaking. I didn't want to take it with me when I transferred to a college in Pittsburgh, PA. So essentially it has been sitting around since then.
Also around my late HS/early college years my Dad and I repaired a blue 1975 Fiat that was pretty rusty. It had come from Colorado. Rear wheel arches were totally gone, carpet was the only thing keeping water from splashing in through the holes in the floor, and the back bumper fell off while we were driving it. It was a real treat. Got it in pretty good shape with a nice coat of red paint and my sister drove it while she was in high school. They sold it while I was away with my original 69 wheels and hubcaps
Hope I didn't bore anybody too much.
--
Stephen
- SLOSpider
- Posts: 1140
- Joined: Wed Mar 03, 2010 2:10 am
- Your car is a: 1973 124 Spider 2.0FI
- Location: Lompoc, Ca USA
Re: New member
Welcome and always good to hear stories of the owners and cars.
1975 124 Spider
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
1976 Mazda Cosmo http://www.mazdacosmo.com
1989 Chevy k5 Blazer
1967 GT Mustang Fastback
-
- Posts: 548
- Joined: Tue Oct 27, 2009 10:17 pm
- Your car is a: 1982 Spider
- Location: Cincinnati OH
Re: New member
Not a problem with the lost keys situation.
You can have a competent locksmith come out to the car with a FIAT blank or two and they can hand cut a new key 4 u. There are posts on this in the archives. From what I remember, it should cost less than $100.
If you don't have a trunk key, the locksmith should be able to do this one too or there's an alternative. On my car, I drilled a small hole 1 inch below the bottom lip of the trunk (hidden by the license plate) stuck in a thin screwdriver and popped the mechanism. I learned this right here on this forum! At this point you could take the lock out and replace or take it to be re-keyed. All this is with the caveat that a '69 trunk mechanism could very well be different than an '82. Again, Check the archives here.
P.S I put a nice tiny rubber plug over the hole in case it were ever needed again.
You can have a competent locksmith come out to the car with a FIAT blank or two and they can hand cut a new key 4 u. There are posts on this in the archives. From what I remember, it should cost less than $100.
If you don't have a trunk key, the locksmith should be able to do this one too or there's an alternative. On my car, I drilled a small hole 1 inch below the bottom lip of the trunk (hidden by the license plate) stuck in a thin screwdriver and popped the mechanism. I learned this right here on this forum! At this point you could take the lock out and replace or take it to be re-keyed. All this is with the caveat that a '69 trunk mechanism could very well be different than an '82. Again, Check the archives here.
P.S I put a nice tiny rubber plug over the hole in case it were ever needed again.
Steve
1982 Red Spider 2000
1919 Old Town Sailing Canoe
1982 Red Spider 2000
1919 Old Town Sailing Canoe
- RRoller123
- Patron 2020
- Posts: 8179
- Joined: Sun Nov 13, 2011 2:04 pm
- Your car is a: 1980 FI SPIDER 2000
- Location: SAGAMORE BEACH, MA USA
Re: New member
+1 on the little drilled hole method to get into the trunk, works like a charm! Had to do it on my '80. But this only applies to cars with the lock mechanism over to the right, in the "2000" emblem.
'80 FI Spider 2000
'74 and '79 X1/9 (past)
'75 BMW R75/6
2011 Chevy Malibu (daily driver)
2010 Chevy Silverado 2500HD Ext Cab 4WD/STD BED
2002 Edgewater 175CC 80HP 4-Stroke Yamaha
2003 Jaguar XK8
2003 Jaguar XKR
2021 Jayco 22RB
2019 Bianchi Torino Bicycle
'74 and '79 X1/9 (past)
'75 BMW R75/6
2011 Chevy Malibu (daily driver)
2010 Chevy Silverado 2500HD Ext Cab 4WD/STD BED
2002 Edgewater 175CC 80HP 4-Stroke Yamaha
2003 Jaguar XK8
2003 Jaguar XKR
2021 Jayco 22RB
2019 Bianchi Torino Bicycle
Re: New member
On my '69 (and anything pre-75) the place you describe is where the key cylinder is. The license plate is further down between the split rear bumper. Hopefully I can figure something out on getting it open.
--
Stephen
--
Stephen