Tell me

[fiat218]

In this photo, I got the rail and crossmember metal piece
As you see they are together like this in the car, the rail does not sit flat,you can see it don't even reach the bottom of the center piece
How does this go

[westy64]

I think your center piece is ill-positioned.
It should not lay on the table while the rail is high above it.
If you lift the center piece, it should find its place better, don't you think ?

[fiat218]

I have a feeling that when the p o smashed down the rails ,that in the same time ,the floor under the rails got beat down,something has to give,I should have bought the whole dam floor pieces

[fiat218]

From snooping at other people's photos,it looks like the rails should lay over the crossmember piece and the tabs lay all flat

[fiat218]

Is any one replacing there carpet?maybe they can take a photo of the floor pan.
If not i will have to remove the carpet in my other one so I can look
Thanks

[westy64]

does this help ?

http://www.fiatspider.com/f08/viewtopic ... ats#p33149

[fiat218]

Has any one had a problem with a beat up? Pushed down floor pan

[SoFlaFiat]

It looks to me that the notch in your new seat rail is cut wrong. I believe it should be a triangular notch, not rectangular.

[fiat218]

Well I got the rails from vicks, I got the center piece from wolf steel
I really have to belive that my floor is smashed down, so nothing will sit straight, I may have to get the back section of the right side and left

[srwilson]

Is any one replacing there carpet?maybe they can take a photo of the floor pan.
If not i will have to remove the carpet in my other one so I can look
Thanks

If you still need a pic, take a look at the first pic.
http://www.fiatspider.com/f08/viewtopic ... 85#p179890

[SLOSpider]

I think that rail is used for later style floors that have the hump for the cat converter. At any case it does not look like the picture on their web site.

Pic from steves car with hump far right rail.

[fiat218]

I got that hum too