Pt. 3 ladies and gents - Enjoy!
Time to tackle the rear end. First I took off one side of the panhard rod, then I disconnected the compensator linkage to the diff, I also loosened the fittings on the flexible center brake hose and clamped it (I'm replacing the hose) until I was ready to drop the axle.

Spring out
That moment when you realize you've gone too far

Before
Masking up the slides
While everything was out, I thought I would spray the wheel wells with a rubberized coating
Now to deal with mess
Decided to replace the master cylinder, to prevent brake fluid from pouring out, put a piece of plastic wrap over the fluid reservoir then tighten the cap
My hand brake cable
So here is a shot of the rear axle all back together, I put in new KYB's, got the compensator hooked up, installed a new hand brake cable, new brake hoses, sandblasted the rotors then wire wheeled them, and sandblasted and painted the dust shield and wheel spacer.
Summer project complete! ... for now
