Hood spring question

[Akgriffith]

Hello all. I need to know the size of the blot which holds the hood spring to the hood. The one I have circled in the picture. I'm missing that bolt and need to find a replacement.

[Akgriffith]

Anybody out there know the size of that bolt, or possibly have an old one laying around? Thanks

[RRoller123]

Try "spiderparts" here on the Forum, I bet John has one.

[geospider]

I may have one on my "extra" hood.
I'll check when I get home this evening. If I have it, will send it.

Geo

[Akgriffith]

I may have one on my "extra" hood.
I'll check when I get home this evening. If I have it, will send it.

Geo

I would really appreciate that! Thanks

[geospider]

Alex,
Sorry: hood, no bolt.

Geo

[Akgriffith]

Alex,
Sorry: hood, no bolt.

Geo

Thanks for checking!

[geospider]

I can size out the bolt if you have the round guide in the hood prop

[Akgriffith]

I do have the round guide. If you could tell me the size that's all I would need and I could buy a new bolt. Thanks again!

[geospider]

http://imgur.com/LdBQd3p

this is it. will need a sleeve and 2 dif washers.
i'll head to hardware store today and see what I find

[geospider]

that is unless you can find a bolt like that

[geospider]

http://www.spiderroadster.com/124hood.htm

sorry for yet another post: #8 but expensive

[geospider]

I just got the bolt a sleeve and 2 washers that will work
PO your address and I will send in the mail tomorrow. Mom was a lot easier just to spend a couple of bucks and get the stuff there was try to tell you what it is. It matches up with mine just fine. So it should work perfectly.

Geo

[Akgriffith]

Thanks Geo! Sent you a PM.