Page 3 of 3

Re: 77 Restore begins

Posted: Fri Feb 08, 2013 11:50 pm
by hallgreghall
Yes I am planning on pulling the engine. I am hoping to pull it in a couple of weeks.

Re: 77 Restore begins

Posted: Wed Feb 20, 2013 8:56 pm
by hallgreghall
A little more progress. My boys think it looks more like a boat than a car at this point.
Image

Image

Re: 77 Restore begins

Posted: Wed Feb 20, 2013 8:57 pm
by rodman
Make sure you Epoxy primer that metal then use some 2K high build primer on it.

Re: 77 Restore begins

Posted: Sat Apr 13, 2013 10:09 pm
by hallgreghall
We were back to working on the car today and found a piece that is not connected to anything. Does anyone know what this is and what it should be hooked up to?

Image

It is in the trunk by the fuel tank.

Re: 77 Restore begins

Posted: Sat Apr 13, 2013 11:52 pm
by SLOSpider
Never saw anything like that. Wiring does not look factory. Is the antenna in that location? Some kind of noise suppressor?

Re: 77 Restore begins

Posted: Sun Apr 14, 2013 12:16 am
by 124JOE
it might be for a power anttena
the power leed
one for up and one for down

Re: 77 Restore begins

Posted: Wed May 22, 2013 12:08 am
by hallgreghall
So we finally got back to working on the car a little this evening. We pulled the doors off and did a little more sanding. Image. Image. I made the mistake of removing the trunk lock linkage, the lock mechanism fell out and springs and small pieces went everywhere. Luckily I found all the pieces and will work on putting it back together later.